Main features:

1: Adapt to the requirements of rapid construction of the main steel structure, can provide a firm platform in a short time, and can use multiple floors of the laying of profiled steel plate, layered pouring concrete slab water construction.

2: In the use of the floor slab as the concrete floor tensile reinforcement, but also improve the stiffness of the floor, save the amount of steel and concrete.

3: Pressure plate surface embossing makes the maximum binding force between the floor bearing plate and concrete, so that the two form a whole, with stiffening ribs, so that the floor bearing plate system has high strength bearing capacity.

4: In the cantilever condition, the floor bearing plate only as a permanent template. The length of the cantilever can be determined according to the cross-section characteristics of the floor bearing plate. In order to prevent the cracking of the cantilever plate, the negative reinforcement should be provided at the support according to the design of the structural engineer.

5: The company's floor bearing plate has passed the national fixed fire extinguishing system and fire resistant component quality testing center of the fire limit detection, as a combination of floor bearing plate without fire spraying, so greatly reduce the cost of the project

Usage:

The profiles of the floor bearing plate are 0.8mm, 1.0mm, 1.2mm, 688mm~940mm wide, 51 mm~ 76mm high. Engineering floor bearing plate and reinforced concrete structure act together, it is a composite structure. The floor bearing plate is laid and connected with the steel beam, the plate end is welded with the steel beam, and the middle is welded with the bolt nail and the steel beam. The floor bearing plates are connected with special clamping pliers and pressing holes; Plug with special galvanized plug plate and floor bearing plate and steel beam spot welding. If it is shaped with arc area floor slab cutting by plasma cutting machine, the incision is smooth, the surface galvanized layer is complete. Floor bearing plate welding adopts manual arc spot welding, electrode IS E4303, diameter 3.2mm, penetration welding point is 16mm. The original design of solder joint spacing 305mm, after the solder joint increased by 1 times, to ensure that the operator when walking floor plate deformation, concrete pouring floor plate end does not leak slurry. When the elevation of the floor is inconsistent, welding steel is adopted to make the horizontal structure step transition. When the elevation is reduced, welding Angle steel is added to the web of I-beam. Channel steel is welded to flange of I-beam when elevation is raised. When the floor has a reserved hole size is generally greater than 500mm×500mm, the first hole is opened, that is, the steel beam is separated by the welded steel joist to increase the stiffness of the hole, and the mesh steel bar is disconnected at the hole and welded with the steel; When the size of the hole is less than 500mm×500mm, the measure of post-opening is adopted, that is, adding a plug partition board on the floor bearing plate, connecting the steel bars of the mesh plate, and cutting the steel bars after the concrete is cast and formed.

Product Application:

The products are widely used in power plant, electric power equipment company, automobile exhibition hall, steel structure workshop, cement warehouse, steel structure office, airport terminal, railway station, stadium, concert hall, grand theater, large supermarket, logistics center, Olympic venues and sports venues and other steel structure buildings.